AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Fusion 360 update12/1/2022 ![]() ![]() Now the correct toolpath should generate just fine. There was a problem with certain turning profile finishing toolpaths where they were not generating when the Z stock width was smaller than the tool nose radius.Now the toolpath starts at the correct Z coordinate (stock front + z clearance). We also fixed an issue with certain turning profile roughing toolpaths where the tool was starting inside the stock.We fixed an issue reported by Farzati.Scott where the tool preview was not showing in the old tool library when you reverted back to it from the new one. ![]() You shouldn’t have to enable Spun Profile to avoid this from happening, so we fixed it and now Turning roughing no longer gouges the model.
0 Comments
Read More
Leave a Reply. |